상세 보기
Automated Terminal-to-Housing Assembly System for Flat Ribbon Cable Harness
- Choi, Eunkyu;
- Seo, Joonho;
- Lee, Seungmin;
- Jeong, Seokhwan
WEB OF SCIENCE
0SCOPUS
0초록
This paper presents a sensor-minimal automated assembly system for bidirectional single-row flat ribbon cable harnesses (FRCHs). Unlike conventional peg-in-hole or single-terminal insertion tasks, FRCH assembly involves mechanically coupled multi-terminal insertion under flexible and dense geometric constraints. To address this problem, the proposed system performs the assembly through a purely mechanical sequence consisting of Cable Alignment, Lean & Slide, Weaving, and Clamping, without relying on active sensing or vision. Each mechanism is designed to progressively reduce correlated terminal misalignment, insertion interference, and instability before final locking. Experiments on bidirectional single-row FRCHs achieved an 83.75% end-to-end process success rate over 80 trials, with success rates of 85.0% and 82.5% in the first and second halves, respectively. The cycle time was 33 s under half-speed operation. To the best of our knowledge, this work presents the first automated prototype for FRCH terminal-to-housing assembly for multi-pin housings. Note to Practitioners-Terminal-to-housing assembly for flat ribbon cable harnesses (FRCHs) remains difficult to automate because multiple terminals are mechanically coupled by a flexible ribbon, making independent alignment and insertion infeasible. Conventional automation methods developed for peg-in-hole or discrete wire harness assembly are therefore not directly applicable. This paper presents a sensor-minimal mechanical assembly system that performs FRCH assembly through Cable Alignment, Lean & Slide, Weaving, and Clamping without relying on vision or active force sensing. For practitioners, the proposed system provides a compact and low-complexity automation concept for repetitive FRCH assembly tasks that still depend heavily on manual labor. Although the current prototype has been validated only at laboratory scale, it demonstrates the feasibility of automated FRCH assembly and provides a foundation for future automation of flexible multi-terminal insertion tasks.
키워드
- 제목
- Automated Terminal-to-Housing Assembly System for Flat Ribbon Cable Harness
- 저자
- Choi, Eunkyu; Seo, Joonho; Lee, Seungmin; Jeong, Seokhwan
- 발행일
- 2026
- 유형
- Article
- 권
- 23
- 페이지
- 1 ~ 1
- 출판사
- Institute of Electrical and Electronics Engineers (IEEE)
- 분량
- 1 페이지
- ISSN
- E 1558-3783
P 1545-5955